How To Change Battery In Honeywell Thermostat Pro Series

How To Change Battery In Honeywell Thermostat Pro Series

How To Change Battery In Honeywell Thermostat Pro Series. Your thermostat will save the time, schedules and any other settings when replacing batteries. Now, remove the old batteries with the new ones.

How To Change Battery In Honeywell Thermostat Pro SeriesHow To Change Battery In Honeywell Thermostat Pro Series
How To Turn On Honeywell Thermostat After Replacing Batteries from globaltorial.blogspot.com

The left battery goes upright, or plus side up, while the right battery goes. Hold on the upper and lower side of the faceplate to depress the tab. You can now replace the old batteries with a pair of new aa batteries.

Turn Off Your Thermostat, Open The Battery Compartment On The Front, And Remove The Batteries.

Take out the dead, old batteries. Pull out the faceplate to open the battery compartment. Open package to find the uwp.

To Replace The Battery In Either Series:

Release batteries from the holder by pressing them out from the hole in the back of the compartment. Refit the thermostat to the wall plate. The left battery goes upright, or plus side up, while the right battery goes.

See also  Man Of The House Game Online

You Can Now Replace The Old Batteries With A Pair Of New Aa Batteries.

Place the thermostat back on the wall, turn it on, and check to make sure that the new batteries work. The left battery goes upright, or plus side up, while the right battery goes. However, if you had upgraded from the 1000 and 2000 series to a 7000, you would have to use the same approach.

Insert Your Fingers At The Bottom Of The Cover Plate, And Pull It Outwards.

Hold on the upper and lower side of the faceplate to depress the tab. Here is how to replace the battery in honeywell 5000 series thermostat. Mostly these thermostats are used in big complexes and.

Have Some Spare Batteries Of Both Aa As Well As Aaa Batteries As Some Thermostats Use Either Of The Two.

Drill holes at marked positions, and then lightly tap supplied wall anchors into the wall using a hammer. Now pull the cover with your fingers to take the cover off. Remove the thermostat from the wall plate.

Leave a Reply

Your email address will not be published.